Grooving method of concealed handle What are the precautions for ground grooving
Lock the screw from the hole on the front of the concealed handle, lock the screw from the back,
Grooving method of concealed handle
Lock the screw from the hole on the front of the concealed handle, lock the screw from the back, and screw the screw into the nut of the concealed handle in front of the door panel. For the embedded concealed handle, first draw the line around the embedded concealed handle with a pencil, and then use the trimming machine to shave the groove.
1. For single hole handle, use a 3mm drill bit to locate the hole to be drilled and use an electric drill to drill a small hole. The handle of the double hole is also a 3mm drill bit, but it must be noted that the positioning hole should be parallel to the drawer face. In addition, the number of holes to be drilled depends on the number of holes to be drilled.
2. If the board can be disassembled or has not been assembled, it can be grooved first, and the depth of grooving is usually adjusted with a table saw. If the cabinet is installed and grooved again, use a trimming machine. The slot is usually 3MM, fixed with glass glue, and the guide rail can cover the slot without seeing the slot.